לינק למוצר באתר היצרן NEO CLASSIC 250
ALL-TUBE monoblock design: uses 10 x Tungsol EL34B output tubes
Driver Stage: High current double 12BH7EH (x2)
Input Tube: 12AT7
BALANCED & UNBALANCED inputs: RCA and XLR jacks (switchable)
MANLEY IRON® Input Transformer for the XLR: 2:1 ratio designed and wound at Manley Labs
MUTE switch: on front panel
TRIODE / Ultra-Linear output mode switching: on front panel
SOFT-START turn on mode: minimizes in-rush current by first powering up amplifier to half voltages
EVER-WARM mode: for standby keeps tubes warmed up at half voltages
MANLEY IRON® Output Transformer: designed and wound at Manley Labs
Front panel bias measurement and adjust: Concealed under the black oval insert
Output Tube Standing Current: 30mA
Set Bias for: 300mVDC measured across each bias tip jack to ground
Large filter / reservoir capacitors: 3800uF x 2
Angled rear of chassis: provides for easy connections
WBT binding posts: CE compliant for European models
Input Sensitivity RCA: Triode = 1.17 V; UL = 1.38 V for full power into 5 Ohms
Input Sensitivity XLR: Triode = 2.56 V; Tetrode = 3.05 V for full power into 5 Ohms
Input Sensitivity RCA Triode: 98.3 mV; UL = 86.6 mV for 1 Watt into 5 Ohms
Input Sensitivity XLR Triode: 227 mV; UL = 200 mV for 1 Watt into 5 Ohms
Gain RCA: Triode = 27.2 dB; UL = 28.3 dB
Gain XLR: Triode = 21.2 dB; UL = 22.3 dB
Input Impedance RCA: 130 kOhm @ 1KHz
Input Impedance XLR: 278 kOhm @ 1KHz; 20 kOhms @ 20KHz; 28 kOhm @ 20Hz
Actual Output Impedance Triode: 0.610 Ohm
Actual Output Impedance Tetrode: 0.698 Ohm
Optimum Speaker Load: 5 Ohms
Damping Factor Triode: 13.1
Damping Factor Tetrode: 11.5
S/N Ratio: 94 dB A-WGT at 1 Watt into 5 Ohms
Dynamic Range: 114 dB A-WGT
Noise Floor: -84 dB or 50 µV A-WGT 1 Watt into 5 Ohms w/Shorted Input
Frequency response -1 dB: Triode = 10 Hz - 30 kHz
Full Power frequency response -1 dB: Triode = 10 Hz - 33 kHz; UL = 10 Hz - 20 kHz to reach 1.5% THD into 5 Ohms
Distortion: Triode = 0.052%; UL = 0.37% BW 10 Hz - 500 kHz at 1 Watt into 5 Ohms
Full Power Triode: 140 W @ 1.5% THD into 5 Ohms
Full Power UL: 250 W @ 1.5% THD into 5 Ohms
Power Consumption: 40 Watts in "EVER-WARM" mode
Power Consumption Idle: 335 Watts
Maximum Power Consumption: 710 Watts at full power
Operating Mains Voltage: Factory set for 100V, 120V or 220-240VAC operation for original destination country's mains voltage.
Operating Mains Voltage: changeable with power transformer replacement and fuse value change.
Mains Voltage Frequency: 50 Hz or 60 Hz
Mains Fuse 100-120VAC operation: MDA 10 Amp SLO-BLO Ceramic Time-Delay fuse
Mains Fuse 220-240VAC operation: MDA 8 Amp SLO-BLO Ceramic Time-Delay fuse
B+ Fuse: MDA 1 1/2A SLO-BLO Ceramic Time-Delay fuse
Badge Illumination: Units produced before 4/2003 use 8V, 0.3A "Fuse-Lamp" 1/4" X 1 1/4" - Serial numbers after N250188 use LED illumination which probably won't burn out
Power Cord: Detachable IEC standard. Appropriate power cord supplied for destination country
Unit Dimensions: W=19" x D=13" x H=9" each
Unit Weight: 69 lbs. each
Shipping Box Dimensions: 22” x 19” x 18”
Shipping Weight: 79 lbs. each
Input Sensitivity RCA: Triode = 1.637 V, Tetrode = 1.837 V for full power
Input Sensitivity XLR: Triode = 3.2 V, Tetrode = 3.6 V for full power
Input Sensitivity Triode: 174 mV for 1 Watt into 8 Ohms
Input Sensitivity Tetrode: 146 mV for 1 Watt into 8 Ohms
Gain Triode: 30 dB
Gain Tetrode: 32 dB
Input Impedance RCA: 116 kOhm @ 1KHz
Input Impedance XLR: 270 kOhm @ 1KHz; 20 kOhms @ 20 kHz; 38 kOhm @ 20Hz
Actual Output Impedance Triode: 0.538 Ohm
Actual Output Impedance Tetrode: 0.465 Ohm
Damping Factor Triode: 14.8
Damping Factor Tetrode: 17.2
Full Power Tetrode: 250W @ 1.5% THD into 5 Ohms
Full Power Triode: 100W @ 1.5% THD into 5 Ohms
הירשמו וקבלו
10% הנחה*
לרכישה הקרובה שלכם!
וגם קבלו עדכונים, מבצעים והנחות לפני כולם!
מעוניין לקבל מבצעים והטבות בליעדיות לחברי מועדון בדוא"ל ובSMS.
הרשם
*ללא כפל מבצעים והנחות.
נציג מטעמנו יצור איתכם קשר בהקדם, תודה.