לינק למוצר באתר היצרן NEO CLASSIC 500
ALL-TUBE monoblock design 10 x KT90EH Electro-Harmonix Russian output tubes
Driver Stage: High current double 12BH7EH (x2)
Input Tube: 12AT7
BALANCED & UNBALANCED inputs: RCA and XLR jacks (switchable)
MANLEY IRON® Input Transformer for the XLR: 2:1 ratio designed and wound at Manley Labs
MUTE switch: on front panel
TRIODE / Ultra-Linear output mode switching: on front panel
SOFT-START turn on mode: minimizes in-rush current by first powering up amplifier to half voltages
EVER-WARM mode: for standby keeps tubes warmed up at half voltages
MANLEY IRON® Output Transformer: designed and wound at Manley Labs
Front panel bias measurement and adjust: Concealed under the black oval insert
Output Tube Standing Current: 30 mA
Set Bias for: 300 mVDC measured across each bias tip jack to ground
Large filter / reservoir capacitors: 3800 uF x 2
Angled rear of chassis: provides for easy connections
WBT binding posts: CE compliant for European models
Input Sensitivity RCA: Triode = 1.9 V; UL = 2.10 V for full power into 5 Ohms
Input Sensitivity XLR: Triode = 4.25 V; Tetrode = 4.67 V for full power into 5 Ohms
Input Sensitivity RCA Triode: 118 mV; UL = 103 mV for 1 watt into 5 Ohms
Input Sensitivity XLR Triode: 265 mV; UL = 228 mV for 1 watt into 5 Ohms
Gain RCA: Triode = 25.5 dB; UL = 26.8 dB
Gain XLR: Triode = 18.5 dB; UL = 19.8 dB
Input Impedance RCA: 130 kOhm @ 1KHz
Input Impedance XLR: 178 kOhm @ 1KHz; 20 kOhms @ 20KHz; 28 kOhm @ 20Hz
Actual Output Impedance Triode: 0.959 Ohm
Actual Output Impedance Tetrode: 1.22 Ohm
Optimum Speaker Load: 5 Ohms
Damping Factor Triode: 8.34
Damping Factor Tetrode: 6.55
S/N Ratio: 74 dB BW 22 Hz-22 kHz; 84 dB A-WGT at 1 Watt into 5 Ohms
Dynamic Range: 110 dB A-WGT
Noise Floor: -75 dBu or 100 µV BW 10Hz-500 kHz; -77.7 dB or 100 µV A-WGT 1 Watt into 5 Ohm w/Shorted Input
Flat Frequency response: Triode = 10 Hz - 30 kHz 1 Watt into 5 Ohms
Full Power frequency response: Triode = 22 Hz - 22 kHz; UL = 22 Hz - 22 kHz to reach 1.5% THD into 5 Ohms
Distortion: Triode = 0.03%; UL = 0.50% BW 10 Hz - 22 kHz at 1 Watt into 5 Ohms
Full Power Triode: 200 W @ 1.5% THD into 5 Ohms
Full Power UL: 470 W @ 1.5% THD into 5 Ohms
Power Consumption: 48 Watts in "EVER-WARM" mode
Power Consumption Idle: 492 Watts
Maximum Power Consumption: 1320 Watts at full power
Operating Mains Voltage: Factory set for 100V, 120V or 220-240VAC operation for original destination country's mains voltage.
Operating Mains Voltage: changeable with power transformer replacement and fuse value change.
Mains Voltage Frequency: 50 Hz or 60 Hz
Mains Fuse 100-120VAC operation: MDA 10 Amp SLO-BLO Ceramic Time-Delay fuse
Mains Fuse 220-240VAC operation: MDA 8 Amp SLO-BLO Ceramic Time-Delay fuse
B+ Fuse: MDA 1 1/2A SLO-BLO Ceramic Time-Delay fuse
Badge Illumination: Units produced before 4/2003 use 8V, 0.3A "Fuse-Lamp" 1/4" X 1 1/4" - Serial numbers after N250188 use LED illumination which probably won't burn out
Power Cord: Detachable IEC standard. Appropriate power cord supplied for destination country
Unit Dimensions: W=19" x D=13" x H=9" each
Unit Weight: 72 lbs. each
Shipping Box Dimensions: 22” x 19” x 18”
Shipping Weight: 83 lbs. each
Input Sensitivity RCA: Triode = 1.637 V, Tetrode = 1.837 V for full power
Input Sensitivity XLR: Triode = 3.2 V, Tetrode = 3.6 V for full power
Input Sensitivity Triode: 174 mV for 1 Watt into 8 Ohms
Input Sensitivity Tetrode: 146 mV for 1 Watt into 8 Ohms
Gain Triode: 30 dB
Gain Tetrode: 32 dB
Input Impedance RCA: 116 kOhm @ 1kHz
Input Impedance XLR: 270 kOhm @ 1kHz; 20 kOhms @ 20 kHz; 38 kOhm @ 20Hz
Actual Output Impedance Triode: 0.538 Ohm
Actual Output Impedance Tetrode: 0.465 Ohm
Damping Factor Triode: 14.8
Damping Factor Tetrode: 17.2
Full Power Tetrode: 500W @ 1.5% THD into 5 Ohms
Full Power Triode: 200W @ 1.5% THD into 5 Ohms
הירשמו וקבלו
10% הנחה*
לרכישה הקרובה שלכם!
וגם קבלו עדכונים, מבצעים והנחות לפני כולם!
מעוניין לקבל מבצעים והטבות בליעדיות לחברי מועדון בדוא"ל ובSMS.
הרשם
*ללא כפל מבצעים והנחות.
נציג מטעמנו יצור איתכם קשר בהקדם, תודה.